09121981
- 我是MM
-
普通会员
最后登陆时间:2015-10-05 19:01:43 |
1#
发表于 2015-04-24 23:05:51
各位好,
我在编译官方提供的[quark_linux_v3.8.7+v1.01]内核,用git初始化之后,自己用menuconfig进行了配置,编译好之后,放在SD卡上启动,看putty的输出,最后就是grub启动内核。不知道是内核没有启动,还是config错了。
我关于内核的串口输出部分配置:
General Setup:
Enable support for printk()
Device Driver:
Character devices
Enable character translations in console
Support for console on virtual terminal
Support for binding and unbinding console drivers
Serial drivers
Support for console on Intel(R) Quark X1000 UART
有哪位做过编译3.8.7内核,求指导。
putty卡在内核启动地方的截图如下:
|
|